Honda Throttle Body Spacer Installation Procedures

1. Park the automobile on a flat surface in an illuminated space and engage the parking brake. Raise the hood of the automotive to entry the engine compartment and consumption manifold, which has the manufacturing facility-installed throttle physique hooked up to it.
2. Accumulate your instruments and prepare your work area. Wipe off extra fluid or dust which may have accrued on the air consumption tube and around the Honda throttle physique before proceeding with the set up of a Honda throttle physique spacer or any air consumption parts. Find the juncture of the air intake tube at the consumption manifold. The air intake tube is connected to the opening of the throttle body, and that is the place most of your attention can be focused.
3. Loosen and free the positive cable from the car’s battery. Reposition the positive cable away from the battery so the cable can’t contact the positive post of the automotive battery whilst you’re installing the throttle physique spacer.
4. Separate the air consumption tube from the throttle body. The type of hose clamp that’s used to safe the hose in place across the opening of the throttle body will determine for those who use a screwdriver or pliers to get the job done. Loosen the hose clamp enough to slide it down the air intake tube and away from the opening of the throttle body.
5. Twist the air consumption tube at the level it meets the throttle body. The air consumption tube sits on a skinny neck that protrudes from the throttle body. When the air consumption tube is twisted slightly and pulled, the tube will come free from the throttle body neck. Pull the air intake tube free from the throttle physique and position the tube away from the opening so you might have quick access to the throttle body.
6. Place a clear rag into the open throttle body now that the air intake tube is disconnected from it. Find the throttle cable that connects to the throttle body. Pull the cable free from its bracket so the throttle body could be freed from the intake manifold with none cabling being connected. Take away all cables that connect to the throttle physique and position them away from the work area.
7. Use a socket or Allen wrench to loosen the retaining bolts of the throttle body. Four bolts secure the throttle body to the intake manifold; to put in a new throttle body spacer, you could separate the throttle physique from the intake manifold to put the brand new throttle physique spacer in between.
8. Insert the throttle body spacer over the opening in the intake manifold. Secure the throttle body over the area and safe it to the intake manifold using the provided bolts that will likely be long sufficient to be inserted through both the factory throttle body and the new efficiency throttle body spacer. Tighten the bolts, then pull the rag out of the throttle body.
9. Connect the throttle cable and take a look at for proper length by having an assistant mash the gas pedal to the ground when you watch the movement. Be sure that the cable manipulates the throttle bracket the same as it did earlier than the brand new throttle physique spacer was installed. Adjust at the cable mount that secures the tip of the cable in place if needed.
10. Connect the air consumption tube again to the manufacturing unit-put in throttle body and tighten the positive battery cable clamp across the positive publish of the car’s car battery.